Jump to content


p2computing

Member Since 26 Sep 2016
Offline Last Active Yesterday, 06:31 PM
-----

Topics I've Started

TDI Swap to Toyota - Questions

02 January 2018 - 12:49 PM

Hey Guys,

 

It's about that time again for another project. This time i'd like to put a diesel into my 91 Toyota Pickup. I did the 12valve cummins Excursion, but everything was too huge, too heavy!

 

Ideally this will be a daily driver, and i've seen these running on just power + ground. Hoping to achieve a similar setup with mine.

 

Questions regarding a VW TDI Engine:

  • Which engines could u achieve standalone functionality without an ECM? Hoping for just ignition to open up fuel, and switched power to keep it open.
  • Is it possible to use a mechanical fuel / injection pump on one to remove the need for an ECM?
  • What options do i have for turbo upgrades / intercooling? I'm not looking for immense power, just stable power at minor gains
  • Any other info would be awesome!

P7100 Idle screw threads

05 October 2017 - 06:51 PM

Hey guys, any of you know the thread size and pitch on the idle screw? Nut fell off :(

12 Valve Cummins, ZF-6, Ford Excursion 4x4

27 September 2017 - 09:08 AM

Hey Guys,

 

Is there any interest on the board here if i were to do a complete write-up on my Excursion build?

 

I'm about 99% done with mine, and while the info is fresh I thought I might make a complete guide on the build from start to finish.

 

Let me know!

 

engine_trans.jpg

 

engine_frame.jpg

 

driver_bay.jpg

 

pass_bay.jpg

 

exc1.jpg

engine_trans.jpg


99-03 Intercooler Needed This Weekend

31 August 2017 - 11:56 AM

Hey Fellas,

 

Looking for a SuperDuty Intercooler this weekend if anyone has one for sale even remotely near Maple Valley, WA


Mild Emergency: P7100 Delivery Valve Holders needed

25 August 2017 - 07:23 PM

Hey guys,

 

Just wrapping up an engine build and i was doing my delivery valves. What i didn't know, was the valve holders have a washer up inside that can be blown out if you use high air pressure.......

 

Soo, i need 2 delivery valve holders, and would prefer stock. Please let me know ASAP if you have a couple you could sell me.

 

Thanks!

 

Pic for reference

dvh.png