Jump to content
Sign in to follow this  
livingez_123

Shop day for the Denali

Recommended Posts

So I've had a check engine light on for 2 years now for a bad knock sensor. Today was it's turn in the shop. I had to pull the intake to get to them so I pulled the valley cover also. There is a TSB out for a knock sensor failure due to water infiltration. So I pulled the rubber plug in the valley cover and found my rear sensor under water. So after a quick clean up and new gaskets for the valley, intake and valve covers it's all back together again. I must say that the valve covers and top of the valve train looked as clean as anything I have seen. No sludge build up or varnishing any where...I must be doing something right with regular maintenance.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×