Jump to content

- - - - -

2000 lb Trip hammer - Sand Point ID to Granite Falls WA

  • Please log in to reply
22 replies to this topic

#21 Austin The DieselTech

Austin The DieselTech
  • Members
  • 2,217 posts
  • Gender:Male
  • Location:Onalaska, Wa

Posted 10 April 2018 - 05:59 PM

I suggest tig welding and V out where you will be welding in the pressure fittings.

Sent from my SM-G900R4 using Tapatalk

#22 Shady

  • Contributor
  • 3,141 posts
  • Gender:Male
  • Location:Granite Falls/Arlington
  • Interests:Traveling to/Retiring in Mexico, Aircraft, Sea Kayaking, Hiking

Posted 11 April 2018 - 10:14 AM

Thanks fellas, I ended up buying a kind of trip hammer called a tire hammer. This particular one is made by a Mennonite knife maker in KY. He has been building these models for some time now and has also built smaller 35# versions, and up to 135# helve hammers. This is the same hammer weight as that Little Giant I was eyeing in Idaho, but a more modern and efficient design. Easier to replace components, less oil, smaller footprint, and actually a much safer design too. Not to mention less expensive than the old school trip hammers. Should be arriving soon... WOOT!!




#23 GTroyer


    Bigger than a Grizz, Gentler than a lamb!

  • Contributor
  • 22,692 posts
  • Gender:Male
  • Location:Reno/Sparks Nv.

Posted 11 April 2018 - 03:54 PM

that's a nice one !!

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users